How can I run a macro from another macro?

frozen_x · Post by **frozen_x** » Jun 8th, ’24, 20:08

Hello

I am currently attempting to run a macro using a macro alias for macro chaining, as certain commands cannot be executed in send mode.
The control click and similar options are only available in send mode, but switching to command mode disrupts it.
Is it possible to chain macros, such as calling one macro from another or having a third macro call the other two macros in sequence?

Cheers,
Frozen

Post by **Marko** » Jun 9th, ’24, 05:59

You can use “Insert another command” macro.

frozen_x · Post by **frozen_x** » Jun 9th, ’24, 09:31

That worked, thank you

One additional question would be, how can I separate new functions via new lines without it executing a next line(enter) for better visibility?
Currently I need to write everything like this:

%func1%%func2%%func3%%func4%

Instead of:

%func1%
%func2%
%func3%
%func4%

Post by **Marko** » Jun 11th, ’24, 20:42

You can’t do this, a new line is always sending a new line.

frozen_x · Post by **frozen_x** » Jun 13th, ’24, 18:02

ah ok, would be cool to see something in the future, that allows for multiline ordering