Open password protected software

Ennovy · Post by **Ennovy** » Feb 14th, ’22, 15:37

Hi,

Let's say I want to start Thunderbird, which is password protected.
When I give the password followed by the <ENTER> key I get a message that the password is not correct.
When I give the password followed bij clicking OK with the mouse the password is accepted.
How can I prevent this? Because it's a FastKeys issue, when I close FK there's no problem.

Thanks in advance for your support
Peter

Post by **Tom** » Feb 14th, ’22, 16:03

You probably have a password or a part of a password defined as one of your shortcuts or auto complete words.

Ennovy · Post by **Ennovy** » Feb 14th, ’22, 16:05

Tom wrote: ↑Feb 14th, ’22, 16:03 You probably have a password or a part of a password defined as one of your shortcuts or auto complete words.

But I don't want to save passwords in FastKeys.

Post by **Tom** » Feb 14th, ’22, 16:12

What I meant is you should check FastKeys auto complete wordlists etc if you have such a word defined. Try disabling wordlists first to see if this is an issue.

Ennovy · Post by **Ennovy** » Feb 14th, ’22, 20:30

Tom wrote: ↑Feb 14th, ’22, 16:12 Try disabling wordlists first to see if this is an issue.

Thank you.